PT. Infokom Internusa | Loop G7860A Packet Transport Network MPLS/CE access node
16597
single,single-product,postid-16597,woocommerce,woocommerce-page,ajax_fade,page_not_loaded,,side_menu_slide_from_right,columns-3,qode-theme-ver-9.1.2,wpb-js-composer js-comp-ver-4.12,vc_responsive

Products

Loop-G7860A

Loop G7860A Packet Transport Network MPLS/CE access node

G7860A is an Access Node to support 10GbE Packet Transport Networks using MPLS-TP or Carrier Ethernet architecture. G7860A, in addition to generic Ethernet traffic, also supports TDM signals including DS0, E1/T1, and STM-n/OC-n via Circuit Emulation and Encapsulation technologies. Clock Synchronization is achieved via SyncE and IEEE 1588v2.

Categories: ,
Description

G7860A supports both MPLS-TP and Carrier Ethernet (EPL, EVPL, EPLAN, EVC defined in MEF) for packet transportation. In addition to native Ethernet transport, G7860A can be used as the gateway for PDH and SDH/SONET networks to enter PSNs using Circuit Emulation and Encapsulation technologies. TDM encapsulation technologies of G7860A support TDMoE, TDMoIP, and TDMoMPLS, while Circuit Emulation technologies supported by G7860A are CESoPSN (Nx64K), SAToP (Unframed E1/T1), and CEP (SDH/SONET paths).

One G7860A with up to 85G packet switching capacity supports six 10GbE SFP+ and four 1GbE SFP built-in interfaces along with 16 E1/T1 built-in ports. With the two hot-swappable plug-in slots, the system capacity can be scaled up with additional E1/T1 ports, STM-n/OC-n, or GbE interfaces.

G7860A provides high availability and reliability required by Carrier, Power Utility, Military, Government and Transportation applications by supporting MPLS-TP LSP 1:1/1+1 protection with protection switching time smaller than 50ms, with section and end-to-end OAM for monitoring. The compact G7860A is only 1U height, but its powerful functions enable customers to construct a hub, ring, or mesh 10G packet network with ultimate ease.

 

Mechanical and Electrical
  • 1U height, 19” width ETSI unit (front access)
  • Power supply: hot swappable DC/AC, dual for redundancy
  • Operating Temperature: -20 ºC to 65 ºC

 

System capacity
  • Up to 6 x 10GbE SFP+ ports
  • Up to 16 x 1GbE Base-T
  • Up to 20 x 1GbE SFP
  • Up to 80 x E1/T1 ports
  • Up to 8 x STM-1/OC-3 ports or 2 x STM-4/OC-12 ports
  • Up to 4 x STM-1/OC-3 MSP pairs or 2 x STM-4/OC-12 pairs
  • 16 x E1/T1 ports with SCSI interface

 

MPLS-TP
  • Any Ethernet port can be configured as NNI (MPLS port) or UNI (Ethernet service port)
  • Bi-directional LSP
  • Static LSP/PW provisioning via NMS
  • Ethernet (VPWS, VPLS, H-VPLS) and TDM (CESoPSN, CEP, and SAToP) services
  • MPLS-TP OAM and QoS

 

Carrier Ethernet
  • L2 Switching/Bridging
  • STP, RSTP, MSTP
  • Port based VLAN and port isolation
  • VLAN Stacking (Q-in-Q)
  • CE OAM
    • CFM: Ethernet Service OAM (802.1ag/Y1731)
    • EFM: Ethernet Link OAM (802.3ah)
  • Flow Control
  • Link Aggregation Control Protocol (LACP)
  • Jumbo Frame (MTU) = 9600

 

Network Protection
  • MPLS-TP
    • LSP 1+1/1:1
    • LSP E2E protection switching < 50ms
    • Based on TP OAM for fault detection
  • Carrier Ethernet
    • ELPS (G.8031) Linear Protection
  • SDH/SONET
    • STM-n/OC-n MSP 1+1 Protection

 

Management
  • Fully manageable via SNMP (v1, v2, v3)
  • Fully manageable via CLI
    • Serial port
    • SSH, Telnet via Ethernet
  • GbE Interface in-bands
  • Account Security
    • Two types of privileges: Operator (read only) and Administrator (read and write)
    • Radius Client Authentication
  • Upload/Download NE configuration
  • Syslog, NTP

 

TDM Services
  • Circuit Emulation
    • Fractional E1/T1 (64K timeslots): CES & multiframe PW
    • Unframed E1/T1: SAToP PW
    • VC-3/4/11/12, VT-1.5/2, STS-1/3: CEP PW
  • PDH Timing recovery: ACR/DCR/System
  • SDH Circuit Emulation over Packet (CEP)
  • Encapsulation
    • PW/LSP (TDM over MPLS-TP),
    • “Dry martini”, MEF 8 (TDM over Ethernet),
    • TDM over IP

 

Ethernet Services
  • E-Line, E-LAN, E-Tree services as defined by MEF 9 and 14 and using VPWS/VPLS
  • Native Ethernet packets supported
  • Encapsulation: PW/LSP (MPLS-TP), VLAN tagging (1Q), VLAN double tagging (Q-in-Q)

 

VPLS
  • VPLS bridging
  • H-VPLS bridging
  • 32K MAC addresses
  • 2K VPLS instances per device
  • Split horizon to prevent forwarding loops

 

CoS/QoS
  • 8 Priority Queues
  • Scheduling: Strict Priority, WRR with Hierarchy
  • Ingress Policing & Egress Shaping per service
  • CIR / PIR (EIR) 2-rate-3-color
  • MPLS: TC/EXP-Inferred-PSC (Per Hop Behavior Scheduling Class) LSP

 

Timing
  • SSM quality level compatible
  • IEEE 1588 v2 (via SyncE only)
    • PTP Clocks: Ordinary/Boundary/Transparent
    • ToD (Time of day)
    • 1-PPS (One Pulse per second) output interface
  • SyncE
    • Synchronous Ethernet from all built-in and plug-in GbE, 10GbE ports
    • ITU-T Ethernet Synchronous Message Channel (ESMC)
  • Stratum 3 timing
  • TDM line clock: E1/T1
  • External clock input and output (2 Mbps / 2 MHz)

Watch Dragon ball super